Capsules Filling Machine Powder

Capsules Filling Machine Powder 1500D is easy to clean, zero dirt is one of its strengths, it is very environmentally friendly and economical. This machine can work efficiently from morning to night under the condition of continuous machine, and it can run with zero noise. Moreover, all kinds of filling rods are easy to change and have zero deviation to ensure the quality of the capsules without scratches or damage.

The adjustment process and method of the gap between the dosing disc and the sealing ring of the automatic hard capsule filling machine. The gap between the dosing disk and the sealing ring of the automatic capsule filling machine is 0.03-0.08mm. When the powder particles are large, the interval can be adjusted to be larger. If the gap is too small, the resistance between the dosing disk and the sealing ring will increase. During the operation of the fully automatic capsule filling machine, it is necessary to adjust the gap when too much powder leakage or excessive resistance is found.

Capsules Filling Machine Powder adjustment method: loosen and remove the five screws on the baffle, loosen the set screw and the set nut, turn the five adjusting bolts evenly and carefully in turn to adjust the height of the sealing ring, check it with a feeler gauge For gaps, check three to five measuring points, the gaps at each point should be consistent, and ensure that the five adjusting sleeves are in contact with the sealing ring. After the inspection is completed, first tighten the set screw, and then tighten the set nut; check the gap again, after confirming that it is correct, install the baffle plate with the screw and fix it.